0
hopefully this guide will help others and would put a smile on my face to see others doing it on theres
The mag release is still fuctional but you do loose one of the screws that holds the magwell in place but it still feels solid.
Before you do this mod you need to figure out what you want to do with your air line. you have a couple of options here:
1. drill a hole on the bottom of the mag and use some 1/8 pipe extensions with a remote fitting on the bottom of the mag.
2. install a 1/8 elbow fitting so it comes out the side of the magwell.
3. Feyds air through set up
My trigger guard needs a little bit of material removed because its pushing on the magwell and making a larger gap where the trigger touches the magwell on the bottom
My egrip is metal so i had to use JB weld to extend the trigger guard to butt up against the magwell. I used more then i should for better strength. if yours is plastic, you should be able to heat it up and slowly bend it into shape. you will have to cut the top of the the grip where the phillips screw holds the trigger guard so its flush for the magwell to slide into.
this was my solution for the air line. i used Feyds guide with a couple of macro line fittings. it keeps it clean and out of the way. i Drilled and taped a hole into the egrip frame so the bracket holds the macroline in place.
if you have any questions please ask and i will help if i can.
