8 replies to this topic

[brody]

Hey guys just got the rampage board for my tm7 and having trouble figuring out how to program BPS or even how to get it to dry fire.I dont have anything in the breach.The instructions say to pull in the trigger and push in the power button it clicks yellow a few times and flashes red and blue then flashs red fast(I know its confusing)And I cant scroll with the trigger?ANY help would be greatly appreciated.I know this is a stupid question but ive been at this for three hours and it seems dumb not to ask.Thanks

[side-effects]

Did you adjust the trigger when you installed the board? If the trigger is not adjusted properly you won't be able to get into programming mode or get it to dry fire.....

[TheEnglishGuy]

Make sure the magnet is flat to the top of the trigger and then try powering it on with the trigger pulled.  The first time seems to need the magnet away from the board on power up before it gets itself setup.

English

[brody]

That was it had the magnet to far up.Now the only issue I hve is getting the fire modes to stick I program them but when I shut the gun off it changes the settings.What am I missing now?And Thanks!

[TheEnglishGuy]

When you move the selector switch, does it flash the different colors in each selector position, or does it just flash Red or not at all?

English

[brody]

TheEnglishGuy, on 22 July 2011 - 08:05 PM, said:

When you move the selector switch, does it flash the different colors in each selector position, or does it just flash Red or not at all?

English

When I move the selector switch it has red on the stock single shot and no colors on other selections.I can program it(an example)I make the third setting true auto(solid blue light)Then go make another setting burst or ramping and when I come back to the auto setting it has changed itself to response or semi.Also if I set them all and try turning it off when I turn it back on the first two settings are always semi and the third one is random.So the selector switch works I just cant program them to stay.I hope im not to confusing.The way im setting them is turning the gun on. Going to a setting. Programing it.Then shutting the gun off to save it,the other way I was trying it was to pull the trigger when I set it and it flashes the purple light for the eyes.So I could be doing this completly wrong,I would not be surprised.Thanks.

[bvdave]

both my boards somehow got locked to semi mode only, tried resetting the boards, changing modes and everything with no luck

[TheEnglishGuy]

This is the exact same thing that happened to 2 of my boards.  I believe its related to going into the Advanced Settings and making a change (I was changing the Pulse settings as recommended by APE).  Nothing seems to work to get it all reset.

I have a ticket open with APE but it seems like there's only one tech there that can work on this.  I'm going to point him to this thread and see if that speeds things up.  If anyone else has this issue please post here.

English

[bvdave]

i left a message with them too and was told they had never before experienced the issue... lol