10 replies to this topic

[Negaduck]

I know some of the people on this site have seen this paintball gun before but its been awhile since i posted anything on it.
I made the stock out of poplar and will soon be starting a forgrip as soon as it starts to warm up outside
so the last time i posted it


and now with the stock almost finished and with its new barrel made by FLASC. The barrel is about 19" long depending on the tip i use


now i want to start on making the foregrip. I know you can't see ti to well on the paper but when it is done it will be over 10" long

[Sunaj]

Looks nice I cant wait to see the finished version. Keep on Moddin my brother.

[Rangers-Radar]

if you're looking for a picture of good modded finished picture, check out cdnmustang's profile for pictures of his dragunov...lot of work but turned out fantastic.  keep up the modding project.

[Negaduck]

Its been a while since i posted anything here so here it is
the foregrip has been put on the back burner for now because i have ordered a AK-47 foregrip from Tacamo and when it gets here i will be making it longer
since people keep bugging me about the camo on it at the fields i got a BT-4 combat to stop that and to put the Iron Horse back to the way it was.
I cut down the BT M-16 clip so it was more level with the stock



I also added the rip-clip but because i run with the scope on a 45 it didn't want to fix until i replaced one of the screws holding the rip-clip on

[SnaRf]

Verry Verry nice :D

[Gato]

Slick. Can't wait to see the rest of it. Good luck.

[longhornjake]

Looking good!

[Negaduck]

it was back in Sept. of 2011 when i ordered my Tacamo AK-47 barrel kit and it has now come in March of 2012, At least now i can start working on modding it and i can see two parts that needs it other then the wood

as it sits here i will be replacing the top tube for a longer one. the hole fore grip needs to be a little bit more the a inch longer. the only part that I'm still not sure on what i should do with it is the part sitting below the fore grip in the picture. My FLASC barrel kit does not fit in the lop part of it and the metal on the part is real thin as it is. I guess i can always try grinding it down and if i grind to much just cut it off.

The only bad thing i can see with this build and barrel kit i want to use is i will have to rip the fore grip apart to change the barrel bore. so I got the
9 inch bore, 5 inch extension and a 3 inch extension plus tip and most of what was added on fits nicely

[longhornjake]

You could always try one of the Flasc micro bore kits and then just use the extension to match exactly what you need.  Then you only have to pull off the very back end...

[Negaduck]

to be honest there is 2 or 3 screws to removed and the 3" extension taken off before i can get at the 9" bore . Now that i know this it isn't that much of a deal.
Right now i'm just trying to replace the top tube before i start on the wood work

[Negaduck]

And now i need to carve the wood but at least its to a point that i can use it again


oh ya to the person that first posted a pic of a apex with teeth ....thanks for the idea