3 replies to this topic

[LONEWOLF666]

Hey fellow modder's and baller's i need your help, At the moment i'm trying to mod the air feed on my BT4 SIR by getting rid of the braided line and ASA and putting a remote fill/male nipple straight into the power tube and connecting the remote up that way.

However the male nipple i'm trying to find is the same one as what you would find on a cobra air remote line (which i have) but i can't seem to find a spare one or remove the nipple from asa adapter at all without damaging it or attacking it with a dremel so here i am turning to you guy's for help.

http://www.lips-pain...ccessories.html   (guerilla cobra remote isolator )

To make it easier what i'm looking for it's the little silver male fill nipple on the marker to ASA adapter (bottom  right of the picture)

If you guy's could help id be grateful

[side-effects]

Looks like the same fitting that PSI works uses on their pro connect remote lines. I know PSI works will sell parts separately if you contact them directly.

Some remote fittings have a large allen key slot on the end that threads into the ASA so you can put an allen key in one end and use a wrench to turn the fitting so you don't have to clamp it in a vise.

[LONEWOLF666]

ok thanks side-effects ill check it out

just checked it out there no way i can use an allen key the only way i can do it is put it in a vise which sucks but ill check out PSI works

[Phantom]

I just leave braided line take off asa and hook up remote right to line.  
http://bt.warrior-on...e/7277-ak04jpg/